Table of Contents
Advertisement
5. Operating Procedures
5.1. ON/OFF SWITCH (Fig.10)
· To switch ON = press green switch button.
· To switch OFF = close cover or press red switch button.
· To unlock the switch cover push the pin on the stop cover.
5.2 SURFACE PLANER MODE:
Note: With surface planing, an irregular surface is planed flat (=
jointed).
- The workpiece rests on top of the infeed table.
- The workpiece is cut on the underside.
- The feed direction of the workpiece is exactly opposite than
when thickness planing.
Workpiece dimensions
- Length: use a push stick to feed workpieces shorter than 250
mm; for workpieces over 1500 mm use a second person for
support.
- Width: max. 410 mm.
- Thickness: min. 5 mm.
Note: The max. depth of cut for a single pass is 3 mm.
1. Assume proper operating position:
position yourself to one side of the infeed table.
2. Set jointer fence as required.
3. Set planing thickness.
4. Place workpiece against jointer fence .
5. Adjust cutterblock cover:
- when planing narrow edges (jointing) or workpieces more than
75 mm thick:
Set cutterblock cover from the side against the workpiece (A,
Fig.12)..
PT410A2216S4053
16寸平压刨
e-stop
-9-
ON
OFF
FIG. 10
FIG. 11
FIG. 12
FIG. 13
A
Advertisement
Table of Contents
