Table of Contents
Advertisement
3.6. DUST CHUTE - INSTALLATION
The dust chute complete with suction connector must be
installed for thickness planing.
CAUTION: The contact pins on the shaft of the dust chute (A,
Fig. 6) must engage properly in the limit switch. Incorrectly
installed dust chute the machine will not start.
Connect a suitable dust collector to the suction connector of the
planer/thickesser.
4. Adjustment
4.1. THICKNESSER TABLE HEIGHT
ADJUSTMENT
With the height setting for the thicknesser bed the planing
thickness (= thickness of the workpiece after planing) is set
when the machine is used for thickness planing.
· Per pass a maximum of 4 mm material can be removed.
· Workpieces of max. 225 mm thickness can be planed. Height
adjustment is made with a handwheel (B, Fig.7). One full turn
of the crank changes the height of the thicknesser bed (C, Fig.7)
by 4 mm.
· Clockwise turning = raises the thicknesser bed
· Counter-clockwise turning = lowers the thicknesser bed. The
set planing thickness is indicated on the scale (D, Fig.7).
4.2. INFEED TABLE HEIGHT ADJUSTMENT
With the height setting for the infeed table (E, Fig,8) the depth of
cut is set when the machine is used for surface planing.
· The scale (F, Fig.8) next to the adjusting lever (G, Fig.8)
corresponds to 1 mm chip removal.
- Per pass a maximum of 3 mm material can be removed.
4.3. JOINTER FENCE ADJUSTMENT
The jointer fence (I, Fig.9) provides lateral support for the
workpiece when surface planing.
· After loosening the lock lever (J, Fig.9) the jointer fence can be
adapted to the workpiece width.
· After loosening the lock lever (K, Fig.9) the jointer fence
extrusion can be tilted to the angle between 0°- 45°.
A
C
D
F
I
I
-8-
FIG. 6
B
FIG. 7
FIG. 8
K
FIG. 9
E
J
Advertisement
Table of Contents
