Sony FW-98BZ50L Reference Manual page 4

• When handling or mounting the LCD Display set, do not
lay down the LCD Display (for applicable LCD Display
model only).
FW-98BZ50L / 98BZ30L
FW-85BZ40L / 85BZ35L / 85BZ30L
FW-75BZ40L / 75BZ35L / 75BZ30L / 65BZ40L / 65BZ35L /
65BZ30L / 55BZ40L / 55BZ35L / 55BZ30L / 50BZ30L /
43BZ30L
• Ensure your LCD Display has adequate ventilation, refer to
the safety documentation.
• For best picture quality, do not expose the screen to direct
illumination or sunlight.
• Avoid installing the LCD Display in a room with reflective
wall and floor materials.
• Avoid moving the LCD Display from a cold area to a warm
area. Sudden room temperature changes may cause
moisture condensation. This may cause the LCD Display
to show poor picture and/or poor color. Should this occur,
allow moisture to evaporate completely before powering
the LCD Display on.
Securing the LCD Display
Sony strongly recommends taking
measures to prevent the LCD Display
from toppling over.
Unsecured LCD Display may topple and
result in property damage, serious
bodily injury or even death.
4
EN
Preventing the LCD Display from Toppling
• Secure the LCD Display to a wall and/or Stand (models
with Table-Top Stand only).
• Do not allow children to play or climb on furniture and
LCD Display.
• Avoid placing or hanging items on the LCD Display.
• Never install the LCD Display on:
 slippery, unstable and/or uneven surfaces.
 furniture that can easily be used as steps, such as a
chest of drawers.
• Install the LCD Display where it cannot be pulled, pushed,
or knocked over.
• Install the LCD Display so that the LCD Display's Table-Top
Stand does not protrude out from the Stand (not
supplied). If the Table-Top Stand protrudes out from the
Stand, it may cause LCD Display to topple over, fall down,
and cause personal injury or damage to the LCD Display.
(Models with Table-Top Stand only)
• Route all AC power cords and connecting cables so that
they are not accessible to curious children.
Recommended Measures to Secure the LCD
Display (models with Table-Top Stand only)
Consider the following measures when securing your LCD
Display to a Stand (not supplied).
1
Secure the Stand for the LCD Display.
Make sure the Stand can adequately support the weight
of the LCD Display. Use two angle braces (not supplied)
to secure the Stand. For each angle brace use the
appropriate hardware to:
• Attach one side of the angle brace to the wall stud.
• Attach the other side to the Stand.
2
Secure the LCD Display to the Stand.
Use the optional hardware listed as follows (not
supplied):
• M6 machine screws (screwed into the LCD Display's
rear cover) (except FW-98BZ50L / 98BZ30L).
• A screw or similar (attach it to the Stand).
• Rope or chain (strong enough to support the weight of
the LCD Display). Make sure that there is no excess
slack in the rope or chain.
Angle brace
(not supplied)
Stand