Assembling The Light Kit - Hunter Aerodyne Installation Manual

After rotating the upper switch housing into
place, tighten all three screws securely.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Hanging Fan

Assembling the LIght Kit

Loosen the two pre-installed screws
Connect the single-pin
connectors from the
light kit assembly to the
connectors from the fan.
Connect the white wires
together. Connect the blue
and black wires together.
Note:
Fan style may vary.
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Wiring Installing Fan Body
Feed the wire plugs through the center
hole of the upper switch housing, then
wrap keyhole slots around the screws
and twist counterclockwise.
Carefully push all switch housing components into the
switch housing, then install the switch housing plate
using the two pre-installed light kit screws.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades Light
8
Remote App
1886