Table of Contents
Advertisement
NH2030, NS2030, FS2330
A Series Water and Remote User Manual
Initial Start Up and Maintenance
Startup
1. Turn the water supply on. Remote models also
open the liquid line valve.
2. Confirm voltage and switch on electrical power.
3. Push and release the On button. The machine will
start in about two minutes.
4. Soon after starting, air cooled models will begin
to blow warm air out the back of the cabinet and
water cooled models will drain warm water from
the condenser drain tube. Remote models will be
discharging warm air from the remote condenser.
After about 5 minutes, ice will begin to drop into
the bin or dispenser.
5. Check the machine for unusual rattles. Tighten
any loose screws, be sure no wires are rubbing
moving parts. Check for tubes that rub. Remote
models check brazed connections for leaks,
retighten as needed.
6. Scan the QR code found behind the front panel
door and complete the warranty registration
online or fill out and mail the included warranty
registration card
7. Notify the user of the maintenance requirements
and whom to call for service.
Maintenance Types
This ice machine needs five types of maintenance:
•
Remote models need their condenser coils
cleaned regularly.
•
All models need scale removed from the water
system.
•
All models require regular sanitization.
•
All models require sensor cleaning.
•
All models require a top bearing check.
Maintenance Frequency
Remote air cooled condenser: At least twice a year, or
every time the unit is cleaned
Scale removal. At least twice a year, in some water
conditions it might be every 3 months. The yellow De-
Scale & Sanitize light will switch on after a set period
of time as a reminder. The default time period is 6
months of power up time.
Sanitizing: Every time the scale is removed or as
often as needed to maintain a sanitary unit.
Sensor Cleaning: Every time the scale is removed.
Top bearing check: At least twice a year or every
time the scale is removed. During the course of
normal operation, some material buildup on top of the
bearing is normal and should be wiped away during
maintenance.
Maintenance Specifics
Maintenance: Remote air cooled condenser
The condenser fins will occasionally need to be
cleaned of leaves, grease or other dirt. Check the coil
every time the ice machine is cleaned.
Maintenance: Exterior Panels
The front and side panels are durable stainless steel.
Fingerprints, dust and grease will require cleaning
with a good quality stainless steel cleaner
Note: If using a sanitizer or a cleaner that contains
chlorine on the panels, after use be sure to wash the
panels with clean water to remove chlorine residue.
Maintenance: Water filters
If the machine has been connected to water filters,
check the cartridges for the date they were replaced
or for the pressure on the gauge. Change cartridges
if they've been installed more than 6 months or if the
pressure drops too much during ice making.
November 2020
Page 14
Advertisement
Table of Contents
