Kenmore D10043MSLRIIH-WP Use & Care Manual page 13

(3) Press to start defrosting and the cooking time remaining will be displayed.
Note: When two-thirds of the defrost time passes, the oven will pause defrost and beep twice to
remind you to turn over the food. Turn over food, close door and press
defrost cycle. If START isn't pressed, the oven will continue to display the remaining time
without resuming the defrost cycle.
COMBINATION FUNCTION (Microwave + Convection)
(1) Press Micro + Conv, "CONV" and "MICRO" will appear in th edisplay.
(2) Press number pads 1through 4 to choose cooking temperature. Temperature selections
( ): 1 = 100, 2 = 275, 3 = 350, 4 = 425. The corresponding temperature, "F", "CONV" and
°F
"MICRO" will display.
(3) Press number pads to enter the cooking time. The maximum cooking time is 99 minutes, 99
seconds.
(4) Press to start cooking. The remaining cook time will display. You can check the selected
temperature by pressing MICRO + CONV during cooking.
Note: When using the convection function, you should place grill pan on the glass tray.
SENSOR MENU ( Sensor Reheat, Sensor Cook )
CAUTION: DO NOT consume foods immediately after the oven finishes cooking. Heated foods,
especially pizza, may burn your mouth. Allow foods to cool to a safe eating temperature.
(1) Place the food in the oven and close the door. Press the appropriate Sensor Menu item pad,
and the oven will start immediately.
(2) For Sensor Reheat or Sensor Cook function, press the corresponding pad repeatedly to select
the menu code. The sensor cooking process starts immediately. When the released steam is
detected by the oven, the remaining cooking time will appear in the display. The oven beeps
4 times when cooking is finished and END will display.
Note:
(1) For best sensor cooking results:
a. The room temperature cannot be over 95 F.
b. The weight of food must be more than 4 oz (110g).
c. The oven cavity, glass tray and utensils must be dry.
(2) During cooking:
a. The food can be covered, but the cover or lid must be vented with a hole to allow steam to
escape.
b. Do not open door or pressing
process and return the oven to standby mode.
c. While using the sensor function, the sensor will self analyze. If there is an error, the sensor
function will stop working, show "E-5" in the display and beep every 2 seconds until you
press pad. This oven will automatically reset the function.
°
at any time during sensor cooking, or will stop the cooking
EN-11
to resume