Table of Contents
Advertisement
•
Power Button/Soft-off Button header (PWRSW)
The 3-1 pin header allows you to connect the system power button. Press the
power button to power up the system, or put the system into sleep or soft-off mode
(depending on the operating system settings).
•
Reset button header (RESET)
The 2-pin header allows you to connect the chassis-mounted reset button. Press the
reset button to reboot the system.
•
Chassis intrusion header (CHASSIS)
The 2-pin header allows you to connect the chassis-mounted intrusion detection
sensor or switch. The chassis intrusion sensor or switch sends a high-level signal
to the header when a chassis component is removed or replaced, the signal is then
generated as a chassis intrusion event.
1.2.2
Rear panel connectors
1
6
1.
DisplayPort. This port is for a DisplayPort-compatible device.
2.
PS/2 Mouse/Keyboard combo port. This port connects to a PS/2 mouse or PS/2
keyboard.
3.
Realtek 2.5Gb Ethernet port. This port allows 2.5Gbps Ethernet connection to a Local
Area Network (LAN) through a network hub. Refer to the table below for the Ethernet
port LED indications.
Realtek 2.5Gb Ethernet port LED indications
Activity Link LED
Status
Description
OFF
No link
GREEN
Linked
BLINKING
Data activity
PRIME B760M-A D4
2
7
8
Speed LED
Status
Description
No link
OFF
2.5 Gbps connection
GREEN
1 Gbps / 100 Mbps /
ORANGE
10 Mbps connection
3
7
ACT/LINK
LED
LAN port
4
5
9
SPEED
LED
1-7
Hide quick links:
Advertisement
Table of Contents
