Installing The Display Assembly - Dell Latitude 9430 2-in-1 Service Manual

hold the left and right sides of the cable's connector head and gently disconnect the display cable from the
system board in a direct upward motion to prevent damage to the connector's pins.
2. Disconnect the camera cable from the connector on the system board and unroute the camera and display cables from the
routing guides on the system board.
3. Remove the six (M2.5x3) screws that secure the display assembly to the system, press the edges of the system near the
hinges, and lift the hinges in the upward direction away from the computer.
4. Open the display assembly to a 180-degree angle and lay the display screen flat, flip the entire computer over.
5. Lift the display assembly off the computer.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
36 Removing and installing components