Introduction - Quantum FastStor 1 Install Manual

Introduction

This guide is designed to enable quick installation of the ADIC FastStor 1
autoloader. For additional product and operation details, please refer to the ADIC
FastStor 1 Installation and User Manual.
The following steps summarize FastStor 1 installation:
•
Unpack the FastStor 1
•
Install the FastStor 1 in a rack
•
Connect the power cable to the FastStor 1
•
Turn on the FastStor 1
•
Remove the transport lock by following the instructions displayed on the front
panel
•
Select the appropriate SCSI IDs and unit options
•
Connect the SCSI interface cable, and optionally the Ethernet cable
•
Install the backup application software and configure it for use with the
FastStor 1
•
Load cartridges into the removable magazines
In order to complete full installation of the FastStor 1, the following additional
materials are required:
•
Simple hand tools (small Phillips screwdriver)
•
SCSI Host adapter card with 68-pin wide HD or VHDC connector
•
Tape application software that is verified with the FastStor 1
•
Up to 8 pieces of the appropriate cartridge type to "stock" the FastStor 1 to full
capacity.
FastStor 1 Quick Installation Guide 1