Table of Contents
Advertisement
Check the center point of the projected
image. If the center point of the projected
image is focused, the adjustment is
complete. If not, repeat steps 3 and 4.
When the peripheral focus cannot be
adjusted
According to the installation conditions, the
peripheral focus ring may not adjust the
focus of the peripheral image. In this case,
adjust the focus by changing the number of
spacers.
1
Remove the projection lens (page 47).
2
Loosen the six screws of the adapter of
the projection lens and remove the
adapter.
Screws (6)
3
Remove the two screws of the spacer
attached inside the adapter.
4
Depending on the focus condition of
peripheral area, add or remove a
spacer.
A spare spacer is supplied with the lens.
Multiple spacers are attached to the
adapter at the time of factory delivery.
Adapter
If the peripheral image is better
focused when the peripheral
focus ring is rotated clockwise all
the way through
Add a spacer.
Attaching/Removing the Projection Lens
Adapter
Spacer
Screws (2)
45
Advertisement
Table of Contents
