A-Series Tape Drives Quick Start Guide
Figure 6 Connecting the Power
and Network Cables
6
2 Secure the unit to the rack with the thumbscrews.
3 Connect the power cable to the rear of the rackmount A-Series tape drive (see
figure
6).
Network port
(to router or switch)
4 Connect one end of the Ethernet cable to the network port located on the rear of the A-
Series tape drive and connect the other end to a network switch or router.
5 Power on the tape drive using the switch on the front panel of the rackmount unit.
6 Proceed to
Configuring the A-Series Tape
Installing the Rackmount Tape Drive
Power cord
connector
To power
Drive.