Download Print this page

Configuration Menu - Magic 100 CNT Manual

Hide thumbs

Table of Contents

Available languages

TESTER MODE

General navigation :

1 Use the arrows to select the test to be performed

2 Press the START/STOP button to start the test

• Voltage test:

This mode allows you to view the voltage at the terminals of the charging clamps and thus use

your MAGIC CHARGER 100 CNT as a voltmeter, in order to measure the battery voltage.

• Start-up test:

The purpose of this mode is to evaluate the state of a vehicle starting system (starter + battery) when the engine is turned on.

This test must be done with the battery connected to the vehicle.

1 Use the arrows to select the nominal voltage of the vehicle battery

2 Press the SELECT button to confirm

3 Connect the clamps to the vehicle battery

4 Start the engine by turning the ignition key

The charger automatically detects the engine start attempt and runs a calculation algorithm

to determine the state of the start system.

Test result: The charger indicates the minimum value of the battery voltage perceived during

the engine start phase, as well as the status of the start system in the form of a gauge.

• Alternator test :

This mode is used to determine the condition of the alternator in the vehicle. This test is performed on a vehicle with the engine

running.

1 Use the arrows to select the nominal voltage of the vehicle battery

2 Press the SELECT button to confirm

Test result: The charger indicates the voltage provided by the vehicle alternator, as well the

alternator status in the form of a gauge.

PROTECTIONS

This device is protected against short circuits and polarity reversals. It has an anti-spark system that prevents sparks when connec-

ting the charger to the battery. The device will not deliver current if there is no battery detected (no voltage in the clamps). This

charger is protected against handling errors by an internal fuse.