Optima D200+ User Manual page 4

Important Safety Instructions
WARNING
1. WARNING - RISK OF EXPLOSIVE GASES.
a.WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS
EACH TIME YOU USE THE CHARGER.
b.To reduce risk of battery explosion, follow these instructions and those marked on the
battery. Review cautionary marking on these products and on engine.
2. Do not use the battery charger unless the battery voltage matches the battery chemistry
and output voltage rating of the charger.
3. Use of an attachment not recommended or sold by OPTIMA
electric shock, or injury to persons.
4. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
5. Extension cords should not be used unless absolutely necessary. Use of an improper
extension cord could result in a risk of fire and electric shock. If an extension cord
must be used make sure:
a.Pins on the plug of the extension cord are the same number, size and shape as those
on the plug of the charger.
b.Use only a properly wired extension cord in good electrical condition.
c. Use an industrial grade / heavy duty UL or CSA approved extension cord. Check extension
cord before use for damage, bent prongs, and cuts. Replace if damaged. Always make
your extension cord connection on the charger side first. After connecting the
extension cord to the charger, proceed to plug the extension cord into a nearby
120 VAC GFCI protected (Ground Fault Circuit Interrupt) outlet.
Below are manufacturer recommendations for the right size UL or CSA Approved
grounded extension cord.
i. Up to 50 feet in length use a 18 AWG extension cord.
ii. 50 to 100 feet in length use a 16 AWG extension cord.
iii. 100 to 150 feet in length use a 14 AWG extension cord.
6. Do not operate charger if any protective AC and DC cable insulation, charging clamps, DC
fuse holders and/or maintainer ring terminals have been damaged or compromised. Return
the charger for service and repair to OPTIMA
7. Do not operate the charger if it has received a sharp blow, direct hit of force, been
dropped or otherwise damaged in any way. Return the charger for service and repair to
OPTIMA ® immediately.
8. Do not disassemble charger. Incorrect reassembly may result in a risk of electric
shock or fire. If service or repair is required, please call OPTIMA
1-888-867-8462 (888-8-OPTIMA) between 9am-5pm (CST) Monday through Friday,
or via email at info@optimabatteries.com. Unauthorized attempts to service, repair or
modify may result in a risk of electrical shock, fire or explosion and will void warranty.
3
®
may result in a risk of fire,
®
immediately.
® customer service at
Important Safety Instructions
9. To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce risk.
10.Do not expose charger to rain or snow.
11. AC POWER CORD CONNECTION INSTRUCTIONS
a. The plug must be plugged into an outlet that is properly installed and protected by
a GFCI outlet.
DANGER
Never alter AC cord or plug provided - If it will not fit outlet, have proper outlet installed by a qualified
electrician. Improper connection can result in a risk of an electric shock.
b. This battery charger is for use on a nominal 120-volt circuit.
Figure A
4