Section 14 − Stick Welding (Smaw) Guidelines - Miller Dynasty 200 DX Owner's Manual

SECTION 14 − STICK WELDING (SMAW) GUIDELINES
14-1. Stick Welding Procedure
Tools Needed:
2
1
OM-245 730 Page 68
Equipment Needed:
5
4
7
Constant Current
Welding Power Source
3
6
!
Weld current starts when
electrode touches work-
piece.
!
Weld current can damage
electronic parts in vehicles.
Disconnect both battery
cables before welding on a
vehicle. Place work clamp
as close to the weld as
possible.
.
Always wear appropriate per-
sonal protective clothing.
1 Workpiece
Make sure workpiece is clean be-
fore welding.
2 Work Clamp
3 Electrode
A small diameter electrode re-
quires less current than a large
one. Follow electrode manufactur-
er's instructions when setting weld
amperage (see Section 14-2).
4 Insulated Electrode Holder
5 Electrode Holder Position
6 Arc Length
Arc length is the distance from the
electrode to the workpiece.
short arc with correct amperage
will give a sharp, crackling sound.
7 Slag
Use a chipping hammer and wire
brush to remove slag. Remove
slag and check weld bead before
making another weld pass.
stick 2010−02 − 151 593
A