Amplifier Setup; Configuration Memories - QSC BASIS 902zz Hardware Manual

8 output cobranet enabled control and monitoring signal processor

Table of Contents

General Information & Configuration Memories

Amplifier Setup

The QSC DataPort-equipped amplifiers connected to the BASIS 902zz must have their power switches in the "on" position. For initial

testing, use the lowest useful gain setting until the system is operating as expected. After the system setup has been verified and

tested, gain settings may be adjusted as required.

Network

The network should be operable and QSControl.net software should be installed/running on the system controller computer.

CobraNet Connection Loss

If you are operating with a valid CobraNet network, and the connection to the network is disrupted, audio will momentarily mute, allow-

ing the BASIS 902zz to synchronize with its internal clock. If CobraNet network connection is re-established, the audio will mute again

while the BASIS 902zz synchronizes with CobraNet.

The BASIS 902zz has non-volatile storage locations that contain settings for the device as well as DSP signal flow. The storage loca-

tions make it possible to set up the BASIS for different situations and quickly recall the setup with or without QSControl.net software

using the front panel controls.

Table of Contents