Specifications Plx 1802, Plx 2502, Plx 3102, Plx 3602 - QSC PLX 1804 User Manual

Specifications PLX 1802, PLX 2502, PLX 3102, PLX 3602

(1)
OUTPUT POWER (Watts)
20 - 20k Hz, 0.05% THD, 8 ohms/Ch.
1k Hz, 0.1% THD (EIA), 8 ohms/Ch.
20 - 20k Hz, 0.05% THD, 4 ohms/Ch.
1k Hz, 0.1% THD (EIA), 4 ohms/Ch.
1k Hz, 0.1% THD (EIA), 2 ohms/Ch.
Bridge Mono, 20 - 20k Hz, 0.1% THD, 8 ohms
Bridge Mono, 1k Hz, 0.1% THD, 8 ohms
Bridge Mono, 1k Hz, 1.0% THD, 4 ohms
DISTORTION, SMPTE-IM
FREQUENCY RESPONSE
SIGNAL to NOISE, unweighted, 20 - 20k Hz
VOLTAGE GAIN
INPUT SENSITIVITY, Vrms
for rated power into 8 ohms
OUTPUT CIRCUIT TYPE
INPUT IMPEDANCE
DYNAMIC HEADROOM
DAMPING FACTOR (8 ohms)
AMPLIFIER PROTECTION
COOLING
CONTROLS
LED INDICATORS
CONNECTORS
LOAD PROTECTION
POWER REQUIREMENTS
DIMENSIONS
(1)
WEIGHT
(1) NOTE: Due to special construction to meet EN-6100, CE models may have 5-12% (0.5 dBw) less power and 1.2 lb (0.6 kg) more weight.
PLX 1802 PLX 2502
320 425
330 450
525 675
575 750
900 1250
1100 1400
1200 1500
1800 2500
<0.02%, all models
20 - 20k Hz, ±0.5 dB, all models
-107 dB -106 dB
31.9 dB 34.0 dB
1.28 (+4.4 dBu) 1.15 (+3.4 dBu)
AB AB/H
10k ohms unbalanced, 20k ohms balanced
2 dB at 4 ohms
>500
Short circuit, open circuit, thermal, ultrasonic and RF protection. Stable into reactive or mismatched loads
Continuously variable speed fan; back-to-front air flow through heat sink array
Front: AC POWER switch, Gain controls (each channel) 21 detents
Back: Input Configuration Switch (Stereo, Parallel, Bridge), Clip Limiters (On/Off)
Subwoofer Switch (100 Hz Low Cut/Full Range/100 Hz High Cut, each channel)
LF Switch (33 Hz Low Cut/Full Range, 1 each channel)
POWER (blue), SIGNAL (green x 2), -10 dB (green x 2), CLIP (red x 2), BRDG (amber), PAR (amber)
Input: 1/4-inch TRS and female XLR; 20k ohm balanced, 10k ohm unbalanced
Output: Speakon connectors: Ch 1, 4-wires (Ch 1 + Ch 2); Ch 2, 2-wires (Ch 2 only)
Binding posts
Turn-on/turnoff muting, DC fault blocking, Clip limiting, infrasonic filter (-3 dB at 5 Hz).
Refer to rear panel serial number label. Configured at factory for 100, 120 or 220-240 VAC, 50- 60 Hz.
19.0" (48.3 cm) W, 3.5" (8.9 cm) H, 13.9" (35.3 cm) D (from front mounting rails, including rear support
ears)
21 pounds (9.5 kg) net; 26 pounds (11.8 kg) shipping
U.S. patent no. 5767744 and patents pending
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
PLX 3102 PLX 3602
550 725
600 775
900 1100
1000 1250
1550 1800
1900 2500
2100 2600
3100 3600
-107 dB -107 dB
35.0 dB 35.9 dB
1.23 (+4.0 dBu) 1.25 (+4.2 dBu)
AB/H AB/H
EN
13