Bissell CLEANVIEW REWIND PET 2489 Series Quick Start Manual page 8

Cleaning the Pre-Motor Filter
WARNING
» To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
» Do not operate vacuum with damp or wet filters or without all filters in place.
1
3
NOTE: Replace this filter every 3 to 6 months. Visit BISSELL.com for replacements.
Maintaining the Post-Motor Filter
1
Recline
vacuum and
lay back for
easier filter
access.
3
NOTE: Replace this filter every 3 to 6 months. Visit BISSELL.com for replacements.
NOTE: The pleated post-motor filter may NOT be washed with water or detergent. If dust
and/or debris accumulates on filter, gently tap the filter on the side of a garbage container.
8 BISSELL.com
Press the
tank release
button and
pull out to
remove dirt
tank.
Allow filter to air
dry completely
before placing
back into the
tank lid. The
carbon filter
should be on top
of the foam filter.
2
Remove the filter by
grasping the sides of
the filter and pulling
out from the vacuum.
Clean or replace filter
as necessary.
2
4
4
Remove carbon
and foam filter
from lid. Hand
wash in warm
water and
rinse well; mild
detergent may be
used if desired.
click
Return tank back
on vacuum and
press firmly until
you hear a "click".
Remove the filter door
on the front of the
vacuum, above the
foot height adjustment
knob, by pushing
down the latch and
pulling the door out.
Replace filter in
machine and replace
filter door by lining
up the sides of the
door and sliding
into place until you
hear a "click".