LG A9T-ULTRA Owner's Manual page 22

OPERATION
22
CAUTION
• If you use the mop nozzle for a long time with the
suction off, the motor may overheat
(recommended duration of use: 80 minutes).
When the moter overheats, the overheating
prevention function is activated and the
appliance is automatically turned off. Use the
appliance after cooling the heat for about one
hour in a cool, well-ventilated place.
Filling the Water Tank
1
Press the PUSH button
tank from the mop nozzle.
2
Open the water inlet cap
water tank and fill the tank with water using
the measuring cup
• Open only one water inlet cap to fill the
water. Opening both caps may cause the
water to flush.
• Do not fill the tank over the MAX line
• Do not put liquid other than water and hot
water in the water tank.
3
Close the water inlet cap tightly.
to remove the water
a
on the side of the
b
.
c
d
• If the water inlet cap is not closed properly,
water may leak.
4
Attach the water tank to the mop nozzle again.
• Insert the 2 tabs
tank into the slots
nozzle. Press down at the centre
the tank in place.
Attaching the Mop Pads
1
Wet both sides of the mop pads with water
then squeeze out any excess water before
attaching the pads.
• Do not attach pads while they are dripping
wet.
• Attaching and using mop pads while they
.
are dry may affect the cleaning results.
2
Place the mop nozzle upside down on the floor.
3
Align and attach the centre of the mop pad
with the centre of the mop attachment plate.
• Attach the Velcro on the mop pad to the mop
plate. Attaching the mop pad upside down
at the front of the water
e
on the top of the mop
f
to lock
g