Advertisement
PARTS LIST
1
Headband
2
Slider
Earpad
3
4
Housing
5
Retractable Cord
Rewind Switch
6
7
Battery Cover
8
Power Switch
Operation Indicator
9
10
Cord Housing
BATTERY INSERTION
1. Slide open the battery cover on the right housing.
2. Insert the provided battery, matching the
Press in on
end first and down on
cle.
3. Close the battery cover.
es
e
at
Changing the Battery
The battery should be changed when the Operation Indicator fades or does not turn on. The
Noise Canceling Function becomes less effective as the battery wears down so make sure to
replace the battery as necessary to maintain the proper performance of the headphones.
NOTES: Misuse of battery could result in leakage. This could cause a fire or explosion.
To prevent this, pay special attention to the following points:
• Be sure to insert the battery with correct positive
• Do not heat, disassemble or short-circuit battery and never dispose of battery by throwing them
in a fire.
• Read the caution displayed on the battery when in use.
ty.
USING THE HEADPHONES
rd.
1. When the power is OFF, the headphone operates without noise canceling
l
function.
2. When the power is ON, the headphone operates with noise canceling function.
3. Rewind the cord and turn the power ON to use the noise canceling function
like an ear plug (e.g. while sleeping on airplane or train)
• Select the appropriate plug adaptor that fits in the airplane headphone plug.
FOLDING THE HEADPHONES
1. Push up the slider on both ends.
2. Place the earpads together.
3. Fold the housing at both ends and push up from the bottom.
ed
ore
HOW TO PULL-OUT/REWIND THE CORD
Pull out: Slowly pull out the cord to the desired
length. Maximum cord length is 4.9ft
(1.5m); stop pulling when the cord end
mark appears.
Rewind: Remove the headphones,
fold it up, and then slide the
rewind switch. (To prevent
accidents, the headphone
is designed not to rewind
when it is in use or
while wearing it.)
If the cord doesn't wind in completely, pull it out and try
rewinding again.
1
2
6
3
4
9
10
5
7
8
and
.
end.
and negative
polarities.
end
mark
SPECIFICATIONS
Frequency response:
10Hz — 22,000Hz
Noise cancellation
40Hz — 1,500Hz
frequency range:
Noise reduction:
more than 12 dB at 300Hz
Sensitivity:
100dB/1mW (when ON), 103dB/1mW (when OFF)
Input impedance:
36Ω (when ON), 64Ω (when OFF)
Power supply:
AAA battery (DC 1.5V) x 1
Battery life*:
approx. 25 hours** (using Manganese AAA battery),
approx. 50 hours** (using Alkaline AAA battery)
*Varies on operating conditions. **Without ambient noise.
0 — 1.5m (4.9ft) (with L type stereo miniplug)
Cord length:
200g (7.06oz) (incl. cord and battery)
Mass:
carrying pouch x 1, AAA battery (R03) x 1,
Accessories:
dual plug adapter (for in-flight use) x 1
Design and specifications subject to change without notice.
English
Advertisement
