Samsung WF405ATPASU/A2 Service Manual page 20

Part
DOOR-LOCK S/W
Heater
Reassembly is in the reverse order of the removal.
18 _ Removal and Reassembly
Figure
1. Open the Door.
2. Remove the 3 screws.
3. Remove the screw holding the Door-Lock S/W.
1. Remove the 3 bolts from the balance weight.
2. Seperate the Connection Housing(3).
3. Remove the heater from the Tub.
Description
Seperate the Wire-Diaphragm with Long-nose plier
and remove it from the Front Frame
Since the Diaphragm can be damaged when
removing it, remove it slowly in one direction.
Remove the Door-Lock S/W.
Remove the connection wire.
(Remove the connector after releasing it by
pressing the latch.)
Remove the nut holding the heater and the heater.
Caution
Make sure to insert
the Heater into the
correct position of the
bracket inside the Tub
when reassembling it.
Otherwise, there is a
risk of fire.
Make sure to push it inwards until the packing part
comes into the Tub completely when reassembling
it so that the packing part is completely stuck to the
Tub.
Fasten the holding nut with a force of 5Kgf/ cm2.
If the nut is not fastened properly, there is a risk of
water leaking.