Hunter Leti Installation Manual page 10

1886
1
Turning off the power
Ensure the power is OFF at the outlet box
and wall switch location before proceeding
with installation.
2
Installing the battery
To access the battery compartment, slide
the battery door up.
Replace the used battery with two AAA
batteries when needed.
3
Wiring the Wall Control
Connect the grounding wire from the wall
control to the ground control from the
switch box using the provided wire nuts.
Connect the "LIVE IN" from the switch
box to the "~VAC" from the wall control
using the provided wire nuts.
Connect the "LIVE OUT" from the switch
box to the "FAN" out from the wall control
using the provided wire nuts.
Push all wires into the switch box.
4
Installing the Wall Control
Install the longer screws through the
slots in the wall control into the switch
box screw holes.
5
Installing the Wall Plate
Install the shorter screws through the
wall control plate and into the screw
holes in the wall control.
6
Turning on the power
9
Ceiling Bracket Downrod
Preparing the Wall Control
OFF OFF
Battery
Door
ON ON
Hanging Fan Wiring
KEY PRESS
Long
Press
Long
Press
Long
Press
Long
Press
Long
Press
Long
Press
7
The remote transmitter is already paired to the
receiver and ready to use. If you need to pair
your remote, cycle power to the fan by turning
power off and back on at the wall switch (or
circuit breaker if necessary). Within three
minutes, do the following:
8
Reference the included remote function
card for information on how to use your
wall control!
Canopy Blades
FUNCTION
LIGHT FUNCTIONS
Light On/Off
Light Dimming
Control
Light High
Light Low
Dimming Mode
+
On/Off
FAN FUNCTIONS
Fan On/Off
Fan Speed
Control
Fan High
Fan Low
Power On/Off
+
Pair Function
Light Remote Troubleshooting