Table of Contents
Advertisement
Features
278
control. Please also read the operating instruc-
tions for the garage door system.
When programming a garage door opener, park
the vehicle outside the garage. Do not run the
engine while programming.
Certain garage door drives are incompatible
with the integrated garage door opener. If you
have difficulty programing the integrated garage
door opener, contact an authorized Mercedes-
Benz Center.
Alternatively, you can call the following tele-
phone assistance services:
USA: Mercedes-Benz Customer Assistance
R
Center at 1-800-FOR-MERCedes
Canada: Customer Service at
R
1-800-387-0100
®
HomeLink
hotline 1-800-355-3515 (free of
R
charge)
More information on HomeLink
patible products is also available online at
http://www.homelink.com.
Notes on the declaration of conformity
(
page 263).
Y
USA: FCC ID: CB2HMIHL4
Canada: IC: 279B-HMIHL4
Important safety notes
G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
page 278).
Y
Garage door remote control A is not included
with the integrated garage door opener.
®
and/or com-
Turn the SmartKey to position 2 in the igni-
X
tion lock (
Select one of buttons ; to ? to use to con-
X
trol the garage door drive.
To start programming mode: press and
X
hold one of buttons ; to ? on the integrated
garage door opener.
The garage door opener is in programming
mode. After a short time, indicator lamp :
lights up yellow.
Indicator lamp : lights up yellow as soon as
button ;, = or ? is stored for the first time.
If the selected button has already been pro-
grammed, indicator lamp : will only light up
yellow after ten seconds have elapsed.
Release button ;, = or ?. Indicator
X
lamp : flashes yellow.
To program the remote control: point
X
garage door remote control A towards but-
tons ; to ? on the rear-view mirror at a dis-
tance of 2 to 8 in (5 to 20 cm).
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
When indicator lamp : lights up green: pro-
gramming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The rolling code
must be synchronized (
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
page 123).
Y
page 279).
Y
Advertisement
Table of Contents
