Meaco 7000 Instruction Manual page 21

Cooling is not effective
Heating is not effective
Machine turns itself off
Machine leaks water when
moved
Display shows 'Ft'
E0
E1
E2
Too much direct sunlight.
Unit has not been running long
enough.
Filter is blocked or dirty.
Room size is too large.
The set point has been
reached.
Internal water container is full.
Internal water container is full.
Display board error.
Temperature sensor is faulty.
Evaporator coil sensor is faulty.
Block the heat gain from the
sun with blinds or curtains.
It takes time to cool a room
due to the heat retain in the
fabric of the room.
Clean the filter and make sure
there is enough space around
the unit and that the air inlet is
not blocked by a wall, furniture
or curtains.
Check whether the air coming
out is warm.
Either accept that the target
has been reached or select a
new set point so that the unit
will run for longer.
Always drain for unit of water
before moving it (see page 14
and 15).
Please see page 15.
Please contact Meaco.
Please contact Meaco.
Please contact Meaco.
20 [EN]