Bissell PET 3 User Manual page 7

Operations
Carpet cleaning
1. Set ReadyTools dial to "FLOOR CLEANING".
2. Plug into proper outlet.
3. Turn the power switch to the ON (I)
position (located on the back of unit)
4. With foot, press the red recline lever (located
on the back of unit).
5. Cleaning Strokes. While pressing the spray trig-
ger, make one slow forward wet pass and another
one back. Caution: Do not overwet.
6. Release the spray trigger and make one
slow forward and backward pass over the
same area.
7. Repeat steps 5 and 6 until solution being pulled
up appears clean.
8. Empty the collection tank when dirty water
reaches the full line, or when the solution tank is
empty.
Empty the collection tank
1. Turn power switch OFF (O) and unplug power
cord from outlet.
2. Remove the collection tank from base of unit.
2a. Release collection tank latches (on each
side) by pulling up from the bottom of latch
and then out.
2b. Carefully remove the top of the tank by
lifting up on the tank handle.
3. Carry collection tank to a toilet or sink.
To empty, pour out contents using
opening at back of tank.
4. Rinse collection tank thoroughly and
replace on unit.
5. Refill solution tank and continue cleaning.
Cleaning with attachments
Your deep cleaner is equipped with a hose
and at least one attachment for cleaning stairs,
upholstery, and more.
1. Important! If using to clean upholstery, check
upholstery tags.
a. Check manufacturer's tag before cleaning.
"W" or "WS" on the tag means you can use
your deep cleaner. If the tag is coded with an
"X" or an "S" (with a diagonal stripe through
it), or says "Dry Clean Only", do not proceed
with any deep cleaning machine. Do not
use on velvet or silk. If manufacturer's tag
is missing or not coded, check with your
furniture dealer.
b. Check for colourfastness in an
inconspicuous place.
1.
2a.
3.
www.BISSELL.com
3. & 4.
Power
Recline
Lever
2b.
7