Vibration Damping System - Jonsered CS 2258 Workshop Manual

Assembly
1. Thread the throttle cables in the connection M
as outlined in figure 55. NOTE! The figure is
shown from underneath.
2. Run the fuel hose D through hole K and hoses
B and C in hole L. See figure 55. Pull the
hoses so that the collars are on each side of
the bottom on the carburettor compartment.
3. Tighten the chain catcher in place.
4. Press the movement limiter H into position. See
figure 53.
5. Tighten the screws F. See figure 51.
6. Hook on the throttle cable E in the intake bel-
low. See figure 50.
7. Fit the tank unit. The two short screws are fitted
to the bottom of the handle bar.
8. Assemble the carburettor as outlined in "As-
sembling the carburettor". Assemble the air
filter and cylinder cover.

7.17 Vibration damping system

Dismantling
1. Dismantle the following parts:
• Bar and chain. See the Operator's Manual.
• Cylinder cover. See the Operator's Manual.
• Tank unit and handle. See "Dismantling the
tank unit".
2. Dismantle the spring on the handle bar using a
4 mm Allen key (see figure 57).
3. Dismantle the springs on the tank unit using
a 4 mm Allen key (tool 502 50 18-01). See
figure 57.
Cleaning and inspection
Clean and inspect all parts.
Assembly
1. Fit the springs on the handle bar using a 4 mm
Allen key (tool 502 50 18-01).
2. Assemble the following parts:
• Tank unit and handle. See "Assembling the
tank unit".
• Cylinder cover. See the Operator's Manual.
• Bar and chain. See the Operator's Manual.
Fig 54
Fig 55
Fig 56
Fig 57
Repair Instructions
43
English -