Table of Contents
Advertisement
REMOTE AUTO START
Optional Keyless Entry and 2-way Transmitter Instructions Included
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING THIS PRODUCT PLEASE READ
THE INSTALLATION DIRECTIONS THOROUGHLY!!
BEFORE YOU BEGIN
This system is compatible with electronic
fuel injected engines only! Not intended for
use with carbureted engines.
• This product must be installed by qualified
personnel according to these instructions and
and observing all safety features.
• Check to see if the vehicle is equipped with
any type of factory security system.
• Check to see if there is a pin switch for the
hood, if not one must be installed.
• Verify that the vehicle starts and idles
properly before beginning the installation.
• Always use a multi-meter to verify wiring.
• Before mounting the product, verify with the
customer the desired location for the valet
switch and LED.
MOUNTING SYSTEM COMPONENTS
Mounting System Module
Mount the remote start module under the dash
where it will be away from moving parts such as
brake pedals, etc.
Mounting LED
Mount the LED in an area that is easily seen
from outside either side of the vehicle. Consult
with the vehicle's owner to verify placement
before drilling.
Mounting Valet Switch
Mount the valet switch in an area that is not
easily seen yet within reach of the driver from
the seated position. Consult with the vehicle's
owner to verify placement before drilling.
Mounting Extended Range Receiver
Mount the extended range receiver (or
transceiver on 2-way equipped systems) to the
inside of the windshield using the supplied
double-sided tape.
location does not obscure the driver's view.
MODULE WIRING
12-Pin Main Harness
• BLACK WIRE - Ground input (-). Connect to
a solid chassis ground that is clean and free of
paint or dirt.
• GRAY/BLACK WIRE - Tachometer input. If
the tach wire is unavailable, leave the
GRAY/BLACK wire disconnected, and set
Remote Start Programmable Feature #1 to
button 2 or 3 setting.
• ORANGE/VIOLET WIRE - Brake switch
input wire. Connect this wire to the brake
switch wire that provides +12V when the brake
pedal is pressed. This safety input must be
connected or the remote start feature will not
operate.
• PINK WIRE - Auxiliary start input (-). This
wire can be used as an optional auxiliary start
7
Make sure the chosen
Advertisement
Table of Contents
