Table of Contents
Advertisement
STOP AND GO
The Stop and Go feature allows the vehicle to
remain running without use of the ignition key
during short stops.
To activate the Stop and Go feature:
1. Make sure the engine is running.
2. Press and hold button 2 for level shift.
3. Press button 2 again.
4. Turn ignition off.
• The doors will unlock.
• The LED will turn on.
• The engine will remain running.
5. Exit the vehicle and lock the doors using
transmitter button 1.
To resume driver control:
1. Unlock the doors by pressing transmitter
button 2.
2. Turn on the ignition.
• The vehicle resumes driver control,
when the brake pedal is pressed.
AUTO COLD START
This feature allows the system to start and run
the vehicle every 1, 2, 4, or 12 hours (selectable
by your installer) in a 24 hour period.This
allows the engine to remain at an operational
temperature in extremely cold weather. Auto
Cold Start interval timing must be chosen
during installation.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1. Press and hold the brake pedal.
2. Press and hold button 2 for level shift.
3. Press button 1.
4. Release the brake pedal.
• The display will show "DAILY 2-1."
• The vehicle will start and run the first
interval to confirm cold start activation.
Press and hold button 2 for level shift then
press button 2 again to shut down remote start
before first run cycle is completed. The Auto
Cold Start feature will remain engaged and
start at the pre-programmed intervals until
deactivated.
NOTE: The Auto Cold Start feature is not
compatible with manual transmission vehicles.
Disengaging the Auto Cold Start feature:
The Auto Cold Start feature can be deactivated
by pressing the brake pedal.
SAFETY FEATURES
The System will not start the vehicle if the
brake pedal is pressed or the hood is open.
Also, if the brake is pressed or the hood is
opened while remote running, the remote start
will shut down.
MANUAL TRANSMISSION MODE
On manual transmission vehicles, the remote
start feature will not operate unless the proper
vehicle exit sequence is performed. This
operating mode protects against in-gear
starting but is not completely without risk.
Installation and safe use of the remote start
feature on a manual transmission vehicle is at
the sole risk of the vehicle's owner, and the
manufacturer
assumes
installation in manual transmission vehicles.
Manual Transmission Mode Exit Sequence: With
engine running, press the unlock button. Turn
ignition off (engine will stay running) and open
the doors, then exit the vehicle. When all
doors are closed, press lock button to turn off
the engine and lock the doors. The system will
be able to remote start as long as the system is
not unlocked prior to remote starting.
NOTE: If the turbo timer feature is
programmed, the engine will not turn off until
the end of the turbo timer program cycle.
3
no
liability
for
Advertisement
Table of Contents
