Pyle PWD301 System Manual page 12

doors will unlock when ignition is turned off.
On/On mode- the doors will automatically lock
or unlock when ignition is turned on and off.
On/Off mode- the doors will automatically lock
with ignition, but not unlock with ignition. Off
mode- no ignition control of door lock system.
2. Door Lock/Unlock Pulse. Selects between
four door lock configurations: a 1-second lock
and unlock pulse (standard), a 3-second lock
and unlock pulse (for vacuum locks), a 1-second
lock and two 1-second unlock pulses (for some
Japanese cars), or a 30-second lock pulse and 1-
second unlock pulse (for automatic window
roll-up on some European cars).
3. Yellow/Black Wire Programming. Selects
between momentary, timed, or latched
operation auxiliary output operation, and
Dome Light operation.
Momentary operation provides an output for .8
seconds.
Timed operation provides an output that turns
on for 10 seconds each time the transmitter
button is pressed. If the button is pressed again
during the 10 seconds, the output will turn off.
Latched operation provides an output that
turns on when the transmitter button is pressed
and turns off when the button is pressed again.
Dome Light operation provides an output that
turns on for 30 seconds whenver the unlock
button is pressed.
4. Lock with Remote Start. Automatically
locks the doors after remote starting.
5. Automatically locks the doors after the
remote start is shut down.
6. Parking Light Mode. Selects the operation
of the parking light output while the vehicle is
remote started. Choose between flashing
output, constant output, and off.
REMOTE START NOTES
Smart Start and Tach Start
In order for the system to properly start and
run the vehicle, the unit must be able to
determine if the engine is cranking or if the
engine is actually running. This system is
equipped with two means of detecting the
engine's run status: Smart Start and Tach Start.
The Smart Start feature detects the engine's run
status using specially designed software that
interprets certain characteristics of the engine,
without connection to the vehicle's tachometer
wire.This feature allows a faster installation, but
may not be compatible with all vehicles, or
under extreme temperatures.
The Tach Start feature requires connection the
the vehicle's tachometer wire, or an injector
wire if the tach wire is not available. The Tach
Start provides reliable operation with virtually
any vehicle, even under extreme temperatures.
Tach Wire Locator
To aid in the locating and testing of a suitable
tach wire, the system's LED can be
programmed to flash when detecting the
presence of a RPM signal. The Gray/Black tach
input wire can then be used to probe for a
proper tach signal.
Programmable Features, Step 10.
Gas and Diesel Modes
The default setting for the engine type is
Gasoline. For diesel vehicles, the engine type
for Remote Start program feature #4 must be
set to one of the two Diesel options. If a glow
plug wire is not available, the unit has a built-in
timer that waits 10 seconds before cranking the
starter (button 2 option). For vehicle's with a
glow plug light (wait-to-start indicator) the
Orange/Violet wire should be connected
(button 3 option) to make sure the glow plugs
are warm up before the engine begins cranking.
12
See Remote Start