Pyle PSW101CM Installation Manual page 3

Tilt flat panel tv bracket, multifunctional double deck wall mount

Hide thumbs Also See for PSW101CM:

Enlarged version

3. For display with protruding HDTV tune or deeply

cur ved backs(Fig b), two 9/16" spacers(R) or two

½" spacers(S) should be used. Stack two spacers

and then install them between display and the

bracket. As shown in Fig 1c.

M4 Fig bit

M6 Fig bit

-6-

Fig b

M5 Fig bit

M8 Fig bit

Fig 1c

WARNING

We are not responsible for any personal injury or product damage due to mishandling,

incorrect mounting, incorrect assembly or incorrect use of this product.

Note:

The supplied wall mounting hardware is not for use on steel stud walls or cold

cinder block walls. If you are uncertain about the nature of your wall, please consult a

qualified contractor. If the hardware you required is not included please contact your

local hardware store .

Caution:

with the maximum weights indicated .See apparatus instructions .Use with products

heavier than the maximum weights indicated may result in instability causing possible

injury .

Step 1: Attach bracket to TV

Check your TV manual to confirm the diameter of bolt to be used or choose an

appropriate bolt according to size, height and position of the holes on your TV. See

pages 4-6 of these instructions for examples.

For correct installing, make sure that hook of every bracket must facing down. Use

selected bolts, spacers and washers for installing bracket at the back of display.

Adjust two brackets to equal heights and level. Once aligned, tightly secure the

bolts.

IMPORTANT:

equipments and injure of person. Don't use electric drill to fasten any bolts.

This Product LCD /Plasma Wall Mount Bracket is intended for use only

Don't force the bolt into the hole, which will cause a damage of

-3-