Table of Contents
Advertisement
Available languages
Available languages
IM2021
This appliance allows you to operate the appliance via your home net-work. A prerequisite is a
permanent WIFI connection to your router and the free app "Smart Life".
We recommend disconnecting the appliance from the power supply when you are away from
home to prevent unintentional switching on while you are on the road!
Commissioning via the App
1.
Scan the corresponding QR code to get directly to the download.
Install the "Smart Life" app. Create a user account.
2.
3.
Activate the WIFI function in the settings of your appliance.
4.
Place the appliance at a distance of about 5 meters to your router.
5.
As long as the power is turned on, the WIFI indicator flashes slowly. After 3 minutes,
the status will be canceled if there is no network configuration, and the indicator light is off. If you
need to re-connect the WIFI, long press the "timer" button for 5 Second to start the network
configuration, the WIFI indicator flashes slowly.
When WIFI indicator flashes slowly, select "Add Device"-"Small Home Appliances"-
6.
"Dehumidifier", and follow the instructions on the display. Select "AP Mode" on upper right of the
app, choose "Confirm indicator slowly blink" and press"Go to Connect" to connect the WIFI
named "SmartLife-XXXX".
7.
Once the appliance has been successfully connected, the WIFI lamp lights up. Now you
can operate the appliance using the app.
8.
Press and hold the Timer button for about 5 seconds, the appliance disconnect, the
WIFI lamp lights off.
TROUBLE SHOOTING
Network connection failed
Network connection timeout
WIFI indicator off
WIFI hotspot disappear and the
WIFI light flash
10. EMPTYING THE WATER TANK
1.
Press the POWER button to turn off the unit.
1.
Pull on the water tank and simply slide out of the body of the dehumidifier.
2.
Empty the water into an area with a drain or outside.
3.
Clean the inside of the tank as well as the outside.
4.
Replace the empty tank back into the unit.
5.
Press the POWER button to resume operating.
6.
If the Water Full light does not extinguish, check that the float is correctly in place.
Solution
1.Check if you select the WIFI named "SmartLife-XXXX".
2.Turn off the machine and unplug the power code and plug
in after 10 seconds, enter the App to connect again.
Long press the "Timer"button or Turn off the machine and
unplug the power code and plug in after 10 seconds.
Turn off the machine and unplug the power code and plug in
after 10 seconds, enter the App to connect again.
27
Advertisement
Table of Contents
