Power Trim And Tilt Models Models - Yamaha F40D Owner's Manual

EMU28175
Procedure for hydro tilt models
1. Place the remote control lever / gear
shift lever in neutral.
N
2. Pull the tilt lock lever up to the release
position.
3. Slightly tilt the outboard motor up to the
desired position and push the tilt lock le-
ver down to the lock position.
4. To return the outboard motor to the nor-
mal running position, pull the tilt lock le-
ver up to the release position and slowly
tilt the outboard motor down.
5. Push the tilt lock lever down to the lock
position.
ZMU03087
EMU32850

Power trim and tilt models models

The outboard motor can be tilted up partially
to allow operation in shallow water.
EWM00660
Place the gear shift in neutral before
G
setting up for shallow water cruising.
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32910
Procedure for power trim and tilt
ZMU03647
1. Place the remote control lever / gear
shift lever in neutral.
WARNING
Operation
ZMU03648
53