Panasonic ES-EY80 Operating Instructions Manual page 11

<DRY epilation>
• DRY epilation is recommended. Before DRY epilation, wipe
away moisture and sweat from the skin. Next, press the
power switch.
<WET epilation>
• For WET epilation, always use
only shower gel. Put the shower
gel on the wet discs and turn on
the switch to make lather.
Use on sufficiently wet skin. If you
notice that some hair is not
removed during epilation, try
switching to DRY epilation.
• The pressure sensor works and the LED light may blink
depending on the amount and type of shower gel used.
Adjust the amount of shower gel or add water to the discs to
dilute the foam.
• Foam forms, making the epilator slippery so you can move it
quickly.
• The appliance may not operate at an ambient temperature
lower than approximately 5 °C.
• Apply the epilator at a 90° angle and slide it slowly over your
skin.
<Epilating legs or arms>
Attach the fast cap or
gentle cap for legs/arms.
Slowly move against
the flow of hair.
<Epilating underarms or bikini-line>
Attach the small epilation
head.
Lightly apply the epilator at
a 90° angle and ensure
close contact with your skin.
Do not move the appliance
back and forth while applied
to the skin.
Lift it away from the skin
and change the direction,
before moving it.
Stretch the skin with your
fingers to prevent sagging,
and slowly move the
appliance against the grain
of the hair.
3~5 cm/sec
11