Trimming And Edging - Remington Omniblade Face & Body Manual

INSTRUCTIONS FOR USE
Switch the product on by rotating the on-off switch to the I mark.
Always comb your beard or moustache with a fine comb before you start trimming.
TO TRIM THE BEARD
1. Select the desired stubble comb. If you are trimming for the first time start with the
maximum stubble comb.
2. Turn the unit on.
3. Place the flat top of the comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull
off the comb and brush the hair off.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps
without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against the
direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. A).

TRIMMING AND EDGING

1. Hold the device with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of beard
line to trim to desired locations in facial area.
3. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
BODY HAIR MAINTENANCE
Attachments
Body blade attachment
Body hair maintenance: Trimming to length
1. Fit the body blade attachment.
2. Body hair can be trimmed to 3 different lengths (3, 6 and 9 mm). Select the desired length
by sliding the comb into one of the three slots on the side of the attachment (Fig. E).
3. Place the flat side of the attachment against the skin.
6