Charging Indicator Light - Remington Omniblade Face & Body Manual

Table of Contents

Advertisement

CHARGING YOUR APPLIANCE
It is recommended to fully charge your appliance before using it for the first time.
1. Ensure the product is switched off.
2. Connect the product to the USB cable and then to the USB end of the cable to a powered
USB port.

CHARGING INDICATOR LIGHT

Charging
The light will come on
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains supply.
To preserve the life of your batteries, let them run out every 6 months then recharge for 4
hours.
Run time from fully charged is up to 40 mins.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. B)
Ensure that the device is switched off before fitting or removing attachments.
To remove, rotate the attachment anti-clockwise until it unlocks and then lift it off.
To fit, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
FITTING AND REMOVING STUBBLE COMBS (FIG. C)
To Fit
Hook the front of the comb over the blade.
Press the back of the comb down until it clicks into place.
To Remove
Lift the tab on the back of the comb upwards until it comes free from the blade.
Fully charged
The light will stay on for 5
minutes then go out
Battery Low
The light will flash for 5
seconds when there are 5
minutes or less of run time
left
GB
AE
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hg3000

Table of Contents