Download Print this page
Remington PG350 Use & Care Manual

Remington PG350 Use & Care Manual

High precision rechargeable all-in-1 grooming system
Hide thumbs Also See for PG350:

Advertisement

Quick Links

To Shave Using the MicroScreen® Shaver Foil Attachment
• Hold the groomer so the MicroScreen® shaver gently
touches your face.
• Use short and well-controlled movements to shave around
your beard or moustache.
NOTE: The MicroScreen® shaver is designed to shave the
detailed areas around your beard, moustache and sideburns. It
is not designed to shave your entire face.
When using electrical appliances, basic precautions
should always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
WARNING - TO REDUCE THE RISK OF BURNS,
ELECTROCUTION AND FIRE OR INJURY TO PERSONS
DANGER - As with most electrical appliances, electrical
parts are electrically live even when the switch is off.
• Do not place or store the groomer or charging adaptor where
it can fall or be knocked into a sink or bath. Do not place in
or drop into water or any other liquid.
• If an appliance falls into water, "unplug it" immediately. Do
not reach into the water.
• Unplug the charging adaptor from the electrical outlet
immediately after use.
IMPORTANT SAFETY INSTRUCTIONS

Advertisement

loading
Need help?

Need help?

Do you have a question about the PG350 and is the answer not in the manual?

Questions and answers

Summary of Contents for Remington PG350

  • Page 1 To Shave Using the MicroScreen® Shaver Foil Attachment • Hold the groomer so the MicroScreen® shaver gently touches your face. • Use short and well-controlled movements to shave around your beard or moustache. NOTE: The MicroScreen® shaver is designed to shave the detailed areas around your beard, moustache and sideburns.
  • Page 2 Remington strongly recommends that an approved Safety Switch (Residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.
  • Page 3 CLEANING AND MAINTAINING YOUR PERSONAL GROOMER Always clean Grooming System attachments regularly to ensure maximum performance and a proper operating life. CLEANING ATTACHMENTS WITH WATER 1. Remove attachment. 2. Rinse ONLY the attachment under warm running water. Do NOT use hot water as this might cause damage. NOTE: Blades must be lubricated again with oil if rinsed under water.
  • Page 4 This appliance conforms to radio interference requirements. Warranty information can be found in the enclosed warranty card. Any product purchased and used commercially carries a limited 90 day warranty. www.remington-products.com.au Remington Products Remington Products Australia Pty Ltd New Zealand Ltd Chifley Business Park...
  • Page 5 High Precision Rechargeable ™ All-in-1 Grooming System Use & Care Manual PG350...
  • Page 6: Key Parts

    RECHARGEABLE ™ ALL-IN-1 GROOMING SYSTEM Use and Care Manual ® Thank you for purchasing your Remington High Precision ™ Rechargeable All-In-1 Grooming System. Inside this manual you will find instructions on using and caring for your personal groomer. KEY PARTS:...
  • Page 7 BEFORE USING YOUR PERSONAL GROOMER Charging • Before using your personal groomer for the first time, charge for 14 to 16 hours. • Place your personal groomer into the charging stand (please see section Attaching The Charging Adaptor To The Charging Stand section) and then plug the charging adaptor unit into a 230/240 volt domestic power outlet.
  • Page 8 ATTACHING THE GROOMING ATTACHMENTS What Attachments to Use 20mm Nose/ear Hair length Foil 30mm wide trimmer trimmer combs shaver trimmer Beard Beard line Eyebrow Moustache Nape of neck Nose Sideburns The attachments are removed by rotating anticlockwise and lifting off. Insert the required attachment and rotate clockwise to lock into position.
  • Page 9 • Turn the groomer’s power switch ON and begin trimming. • Start trimming under your chin, and following your jawbone line. Work toward your ear and upper beard line using an upward motion. Allow the hair length attachment to follow the contour of your face.
  • Page 10 • When finished trimming, turn the power to OFF. To Define The Beard Line • Hold the groomer with the either the 20mm or 30mm trimmer blade facing you. • Start with the edge of the beard line and with the cutting blades resting lightly against your skin.