Operating - Medisana LT 480 Instruction Manual

3 Operating

GB
3.1
Commis-
sioning
3.2
Application
18
Place the device on a stable, level surface (e.g. on a table). Make
•
sure that the device will not drop or fall down. Use the fold-out
5
stand on the rear side.
• Alternatively: Fastening of the Therapy Light on a wall. There
is a mounting hole
mounting hole the appliance can be fixed on the wall with screw.
Depending on the type of wall, an appropriate screw must be
used, may be with pegs. E.g. for concrete wall, stainless steel
self-tapping screw which is screwed into an anchor. The screw
and the anchor are not included in the scope of delivery. Impor-
tant: If the mounting hole or back housing is cracked or dam-
aged, do not fix the appliance on the wall. Please contact cus-
tomer service or the dealer for assistance.
• Place the device approx. 20 to 60 cm away from your eyes. The
light should reach your face sideways.
• Connect the power plug to the socket.
NOTE
• Set up the device in a place near a mains socket.
1. Flip the On-/Off-switch
2. Flip the On-/Off-switch
NOTE
• The tube develops its full luminosity after a couple of
minutes. When switched on, the brightness of the tube
may be visibly lower at first.
As long as you enjoy the soothing light of the device, you may read
a book, phone or do your work. Always keep in mind to keep the
correct distance between the device and your eyes (= 20 to 60 cm).
Recommended use regarding the duration of application:
Distance
60 cm
40 cm
20 cm
• The closer you are to the panel, the shorter you will have to use
the device to achieve the desired effect.
• Do not look directly into the light or the light screen for a longer
period of time.
2
on the rear side of the appliance. At this
3
I
to position
3
0
to position
Application duration
approx. 2 hours
approx. 60 minutes
approx. 30 minutes
to switch on the device.
to switch off the device.