Advertisement
The Quick Connects
There are four sets of quick connects (plug
and socket) on the sprayer: tank inlet, tank
outlet, handgun liquid inlet, and handgun air
inlet.
To disconnect the quick connects:
1. Slide the sleeve on the quick
connect socket up.
2. While holding the sleeve up, pull the
socket off the quick connect plug.
To connect the quick connects:
1. Slide the sleeve of the quick connect
socket up.
2. While holding the sleeve up, push
the socket onto the quick connect
plug.
3. Release the sleeve.
4. Pull on the socket body to ensure
that it is properly seated and cannot
be pulled off the plug when the
sleeve is down.
The Tank
The tank should be thoroughly cleaned
immediately after each use by triple-rinsing
the tank; a commercially available tank
cleaner may be used and is recommended
when the unit is used to spray wettable
powders on a regular basis.
Note: Do not operate the sprayer when the
tank lid is not securely closed. Tank
agitation is powerful and liquid may splash
out if the lid is not closed.
To open the tank:
1. Push up the lever on the tank lid so
it is vertical. This depressurizes the
tank.
2. Pull the handle of the tank lid up.
3. Holding on to the handle, rotate the
tank lid 90° clockwise.
4. Pull out the tank lid. Notice the
direction of the tank lid in
relationship to the tank opening.
To close the tank:
1. Slide the lid into the tank opening,
using the same direction as when it
was removed.
2. Rotate the lid 90° counterclockwise.
3. While pulling the lid up to seal it
against the tank opening, push
down on the lid handle until it is
parallel with the tank lid.
4. Push the pressure valve lever down
so it is horizontal.
Advertisement
