Related Manuals for Pullman Holt MAGNETspray
Summary of Contents for Pullman Holt MAGNETspray
- Page 1 OWNER’S MANUAL FOR THE MAGNETspray Pullman-Holt Corporation Main Office: 10702 North 46 Street Tampa, FL. 33617 Phone: (813) 971-2223 · FAX: (813) 971-6090...
- Page 2 To Operate: Prepare the tank mix. Connect the twinline hose to the front panel. Connect the twinline hose to the liquid and air leaders on the handgun. If using the plastic bottle, connect the grey hose of the plastic bottle hose assembly instead of the solution hose of the twinline hose to the liquid leader.
- Page 5 The Nozzle Assembly The nozzle assembly is located at the end of the handgun wand. It is composed of a nozzle base, internal o-ring, Teflon ring, cover, external o-ring, and a hood (see Diagram 5). To access nozzle components, just unscrew the nozzle cover by hand. In order to optimize nozzle life and achieve maximum spray efficiency, the nozzle must be properly maintained.
-
Page 6: The Air & Liquid Delivery System
The Air & Liquid Delivery System The Air Compressor The air compressor produces compressed air which atomizes and propels the liquid. It plugs into a 110 volt electrical source. Use the unit with an extension cord of no more than 50 feet and rated for no less than 15 amp service. - Page 7 The Quick Connects There are four sets of quick connects (plug and socket) on the sprayer: tank inlet, tank outlet, handgun liquid inlet, and handgun air inlet. To disconnect the quick connects: 1. Slide the sleeve on the quick connect socket up. 2.
- Page 8 The Handgun The handgun is held by the operator during spraying. Activation of the trigger causes liquid to spray. The handgun has the following user-serviceable parts: the air filter, the liquid filter assembly, the nozzle assembly, and the batteries. Except for the batteries, which are accessed by removing the battery cover, nothing inside the handgun shell is user-serviceable.
- Page 9 The Batteries The nozzle charging operates on two 9 volt rechargeable batteries which are located in the base of the handgun. In average conditions, the batteries will last 5-10 hours of operation on a charge. They should be recharged when the charging indicator on top of the handgun shell doesn’t glow when the trigger is engaged during operation.
- Page 10 The Liquid Filter Assembly The liquid filter assemby is located outside the base of the handgun. It is composed of these parts: a 1/8” NPT body (item 10), a strainer (item 11), and a cap (item 12). The To disassemble, clean and reassemble the liquid filter assembly: 1.
-
Page 11: Troubleshooting Guide
Problem: Air pressure of spray appears low: 1. Clean the liquid filter assembly. See “The Liquid Filter Assembly”. 2. Make sure that the liquid filter assembly is installed correctly. See Diagram 3 on p. 12. 3. Make sure that the air filter is installed correctly. See Diagram 2 on p. 11. 4. - Page 13 Unlike conventional sprayers, your sprayer uses a different method for chemical application. Therefore, new techniques must be used to spray and new formulas developed to properly prepare tank mix. This section will discuss proper spray techniques and how to prepare a tank mix. Note: When using unfamiliar equipment or chemicals, always test on a small area before treating the entire crop.