Advertisement
The Air & Liquid Delivery System
The Air Compressor
The air compressor produces compressed
air which atomizes and propels the liquid. It
plugs into a 110 volt electrical source. Use
the unit with an extension cord of no more
than 50 feet and rated for no less than 15
amp service. The On/Off switch is on the
side of the air compressor. The compressor
has an adjustable relief valve on the back.
It should be set between 70 and 100 psi.
The Front Panel Air Connection
The second tee routes the air to the top ¼"
female ball swivel (FBS) fitting on the front
panel of the sprayer. The ¼" end of the air
hose of the twinline hose connects to this
fitting. Use an 11/16" wrench on the FBS
and 9/16" wrench on the twinline hose
fitting. The other end of the twinline hose
connects to the air leader of the handgun.
The Tank Pressure Regulator
Figure 2. The Air and Liquid Delivery Systems
The second tee also routes air to the tank
pressure regulator. It corresponds with the
pressure gauge on the left side of the front
panel. The regulator is operated by pulling
out the dial and turning it clockwise to
increase pressure or counter-clockwise to
decrease pressure. It should be set
between 12 and 15 psi. Once the desired
pressure is achieved, push in the dial to lock
it in place.
Note: For best results, set the pressure
from a lower pressure to a higher pressure.
If the pressure is set too high, adjust the
regulator below the desired pressure then
adjust it up to the desired pressure.
Two lines run from the tank pressure
regulator. One line runs to the tank
pressure gauge on the front panel. The
other runs to the inlet quick connect on the
tank.
Advertisement
