Advertisement
Quick Links
FMT5.0 instruction manual
Initial preparation work:
First set up the antenna cable and connect it to the transmitter's RFOUT
port, then plug the power cord into the transmitter's power outlet. Next,
insert the audio cable to the XLR header or RCA outlet, the outlet is
divided into two channels. Connection is complete, please turn on the
transmitter panel POWER button, the device starts.
Transmitter boot interface
Model / equipment name / manufacturer information
Advertisement
Related Manuals for Warner RF FMT5.0-50
Summary of Contents for Warner RF FMT5.0-50
- Page 1 FMT5.0 instruction manual Initial preparation work: First set up the antenna cable and connect it to the transmitter's RFOUT port, then plug the power cord into the transmitter's power outlet. Next, insert the audio cable to the XLR header or RCA outlet, the outlet is divided into two channels.
- Page 2 The transmitter starts default configuration Transmitter boot. The progress bar enters the selected setting in about 10 seconds. Turn the knob to select, short press the knob to confirm. Last config Last configuration, the latest shutdown configuration. Default config default configuration, the system default frequency 98MHZ / power OW / stereo + external modulation / audio pre-emphasis 0 / volume gain 0dB.
- Page 3 Current frequency: current frequency Frequency setting: Set the frequency Turn the knob to adjust the frequency setting, short press the knob to confirm the frequency setting. The PLL locks again for each frequency setting. After the lock is completed, return to menu 1 frequency setting.
- Page 4 Short press the knob to enter the signal modulation setting. Current signal mode: Current signal mode Signal mode setting: Signal mode setting STEREO + EXT MOD Stereo + External Modulation Input MONO + EXT MOD Mono + External Modulation Input EXT MOD External Modulation Input STEREO Stereo Input Turn the knob to adjust the signal mode setting, short press the knob to confirm the signal...
- Page 5 Current pre-emphasis: The current pre-emphasis Pre-emphasis setting: Pre-emphasis setting Turn the knob to adjust the audio pre-emphasis setting, short press the knob to confirm the audio pre-emphasis setting. And return to menu 4 Audio Pre-emphasis Settings. Menu 5 Audio Gain Setting Short press the knob to enter the audio gain setting.
- Page 6 Menu 6 External Modulation Gain Setting Short press the knob to set the external modulation gain. Turn the knob to adjust the external modulation gain in real time. If you want to set mute, adjust to MUTE. Short press the knob to exit the external modulation gain setting.
- Page 7 Warning: V.S.W.R standing wave high! Please check the antenna and cable connection. Warning: the temperature inside the machine is high! (More than 70 ℃) Please keep the room clean and does not exceed 40 ℃.