Advertisement
Quick Links
Advertisement
Related Manuals for Warner RF FMT5.0-4U Series
Summary of Contents for Warner RF FMT5.0-4U Series
- Page 1 Warner RF FMT5.0-4U Series FM transmitter Manual...
-
Page 2: Table Of Contents
目录 Preparation work...............................3 Transmitter operation interface..........................4 1. Startup and system loading.........................4 2. Main interface and setting.........................4 3. Alarm information............................10 4. Transmitter power module information....................11 Routine maintenance of transmitter........................12 A letter from the manufacturer..........................12... -
Page 3: Preparation Work
Preparation work Firstly, please set up the antenna cable and link it to the RFOUT port in the back of the transmitter. If you need to monitor equipment's signals, please link to the MONITER output port on the transmitter panel, the output signal is -50DB. -
Page 4: Transmitter Operation Interface
Transmitter operation interface 1. Startup and system loading 2. Main interface and setting Current frequency Menu setting This shows the audio mode, UV table for audio level L and R channels, and modulation level table M Modulation mode Audio ore-emphasis RTC clock... - Page 5 Touching the above area will switch to the RF monitoring page below. RF amplifier working voltage Pa1-Pa6 represents the output ADC value of the 6 amplification modules. When the ADC value of any one or more modules is lower than 50% of the highest value of one of the module ADCs, the transmitter will turn off the RF output and prompt the module alarm page.
- Page 6 System setting interface Frequency setting Forward power setting Audio signal modulation setting Frequency setting Manually set frequency Test antenna ’ s VSWR Manually set frequency Set as minimum frequency of 87.50MHz Set as maximum frequency of 108.00MHz Speed up the frequency to move left Speed up the frequency to move right...
- Page 7 Forward power setting Power adjustment with 1W step Power turn off output power, low efficiency output power, low efficiency 100% output power, high efficiency Confirm Audio signal and modulation setting Audio channel setting Audio level setting Audio setting pre-emphasis Modulation mode setting Signal level Setting for SCA and RDS Audio channel setting...
- Page 8 Audio level setting Press the key to adjust the amplitude of the audio level and adjust the audio input signal to about 100% of the UV table display of L and R. Modulation M meter indicates a range of about 75KHz. Audio pre-emphasis setting corresponding Please...
- Page 9 Signal level setting for SCA and RDS Press the key to adjust the signal level of SCA or System information setting Model Version Current continuously working hours Total working hours History alarm information record Store up to 9 alarm records, including its type and status Turn the page forward and backward and clear the alarm record...
-
Page 10: Alarm Information
RTC clock setting Please set the local time when first using it Password setting Disable menu password lock Change default password 3. Alarm information The transmitter self-safety protection is activated due to the high return power of the antenna or cable. The power will be turned off and please check the condition of antenna and cable... -
Page 11: Transmitter Power Module Information
Because the room temperature is too high or the ventilation system is blocked by too much dust inside the transmitter, resulting in high internal temperature and causing overheating protection of the transmitter. The power will be turned off and please check the room temperature to remove dust inside the transmitter. -
Page 12: Routine Maintenance Of Transmitter
50CM. A letter from the manufacturer Thank you for choosing the equipment produced by Warner RF Electronic Device co., ltd. We established our business in China since 2008 and have been committed to providing users with the most cost-effective and humanized products in the broadcast transmitter industry.