Leuchtie Easy Charge Operating Instructions Manual

IMPORTANT DOCUMENT – PLEASE RETAIN!
Operating instructions
LEUCHTIE
with motion sensor
easily rechargeable via USB charging station

Initial start-up

Before using the LEUCHTIE for the first time please remove the transport protection (insulation cap). It is the
red stopper located on the side without size label on the light tube.
Removing the insulation cap:
1. Separate the tube from the battery
pack by pulling them apart with slight
angular movements, taking care not to
use excessive force (1).
In doing so, hold the silicone sleeve
onto the battery compartment.
2. Remove the red insulation cap (2) and
discard.
Fix the attachment loop:
3. In order to secure the LEUCHTIE to a
collar or harness with the enclosed
fixation loop, pull the open end of the
tube through both transparent rubber
rings of the loop (3).
Closing:
4. Insert the end of the tube straight into
the battery compartment. Be careful
not to bend the contact spring.
5. Press the battery pack and the tube
firmly together as far as possible, until
they are closed completely.
IMPORTANT: There must be no gap
between the battery pack and the tube
(see also figures page 3).
Turning the LEUCHTIE on and off
Simply slip the LEUCHTIE over the dog's
head and it will turn on automatically by
sensor as soon as the battery pack points
downwards and the LEUCHTIE is in motion.
When the battery pack faces upwards the
LEUCHTIE will turn off slowly after approx.
one minute. Therefore,
LEUCHTIE e.g. on a hook for storage.
®
Easy Charge
suspend the
Effective 06/2023