Leuchtie Standard Quick Start Manual

The innovative led- light collar for dogs

Advertisement

First start up/ activating
Before you use the LEUCHTIE for the first time, you must remove the battery isolating cap.
(Transport lock)
The isolation cap is fixed on the side opposite the LEUCHTIE brand label.
Roll both of the silicone sleeves onto the light
tube till the joint is free.Your hands should be
grease-free. (Optionally dust with flour lightly
before starting!)
Pull the light tube and the battery pack apart
while twisting the joint slightly, taking care not to
use excessive force.
cap (2).
Push the light tube back into the battery compartment as far as possible and roll the silicon
sleeve back centred over the joint.
The operating time using 2 Alkaline batteries type N / LR 1 is about 50 hours.
Please use batteries of the brand Alkaline!
Please remove empty batteries immediately!
Please remove both batteries in case of longer disuse (e. g. in the summer).
Note:
You may notice some liquid around the batteries. This is an electronic contact spray, which is used
during manufacture and does not need to be removed.
Switching on the LEUCHTIE
LEUCHTIE switches on automatically, if the battery compartment is hanging down or the LEUCHTIE
is moved or shaken. Simply pull the LEUCHTIE over the dog's head and it will switch on
automatically when the batteries are hanging in the lowermost position. Since the batteries are the
heaviest part they will always remain hanging down keeping the light on.
Switching off the LEUCHTIE
LEUCHTIE switches off itself after 1-2 minutes if the battery compartment is hanging up. Keep
LEUCHTIE hanging with the battery compartment on top (for example on a wardrobe).
Cleaning
Clean the LEUCHTIE in warm water and soap or mild detergent if required.
Do not use aggressive or solvent-based cleaners.
sleeves don't get out of place so that no moisture is getting inside.
LEUCHTIE
the innovative LED- light collar for dogs
Thank you for choosing LEUCHTIE to enhance your and your
dog's safety. For best performance and longevity please read
and follow the instructions below.
Page 1: First activation
Page 2: Battery change
Remove the red isolating
®
Standard-
Page 3: Trouble shooting
During cleaning please make sure that the silicon
January 2013
Page 4: Safety info

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Standard and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Leuchtie Standard

  • Page 1 LEUCHTIE switches on automatically, if the battery compartment is hanging down or the LEUCHTIE is moved or shaken. Simply pull the LEUCHTIE over the dog’s head and it will switch on automatically when the batteries are hanging in the lowermost position. Since the batteries are the heaviest part they will always remain hanging down keeping the light on.
  • Page 2 Replace the batteries in a clean, dry place and make sure that the LEUCHTIE is also clean and dry. Always replace both batteries at the same time. If LEUCHTIE is stiff and cold get it to room temperature or heat it at the heating or with a hair-dryer (max. 40°C) so the battery changing is easier.
  • Page 3 Then turn the ring on the neck into the right position until it glows – the dog will hardly realize that. Due to the fact that the putting of the LEUCHTIE on your dog is closely connected with walking your dog, the dog will soon look forward to it.
  • Page 4 Use the LEUCHTIE only for its intended purpose. • Before the first use, make sure the LEUCHTIE is not too tight around the dogs neck, and that • it can be removed easily. If you have purchased a LEUCHTIE that is too tight, and you cannot remove it, then you can pull it apart as per battery replacement instructions on page 3.

Table of Contents