Display Setup-Cs Edit - Honeywell S7800A1167 Manual

7800 SERIES S7800A1167 KEYBOARD DISPLAY MODULE
Fig. 81. Select/Exit screen.
Choose Select.
The display will sequence once through the Call Service
message you have entered during the CS Edit setup.
Below is the default message.
Press ENTER using the two ENTER buttons at the same time
to select.
Fig. 82. Select/Exit screen.
Choose Select.
Fig. 83. LOCKOUT screen.
Displayed for two seconds.
Fig. 84. CALL SERVICE screen.
Fig. 85. Blank screen.
The blank screen is displayed for two seconds.
When done, the display will be:
Fig. 86. DISPLAY Setup/Select CS TEST screen.
Press ENTER using the two ENTER buttons at the same time.
65-0311—02
Fig. 87. Select/Exit screen.
Choose Exit.
You will be taken completely out of the Setup menu.
Display Setup—CS EDIT
CS EDIT allows customizing or personalizing a Call Service
message. Three screens of messages are available. Each
screen has two lines of text with 20 characters available. See
Table 9 for available characters. This message will be
displayed with the 7800 SERIES is in a lockout condition in
place of the normal Lockout Fault condition. Note that the Call
Service feature must be turned ON using the CS ON/OFF
selection.
To access the CS EDIT menu:
Press the left three buttons of the KDM for one second, then
release.
DISPLAY Setup will appear. If you have a personal password,
enter it to enter Setup.
Fig. 88. DISPLAY Setup/PASSWORD screen.
Press ENTER by pressing the two ENTER buttons at the same
time.
Fig. 89. Select/Exit screen.
Choose Select.
Fig. 90. DISPLAY Setup/Select CLONE screen.
Use the down arrow to scroll down through menu choices until
CS EDIT appears.
Fig. 91. DISPLAY Setup/Select CS EDIT screen.
Press ENTER using the two ENTER buttons at the same time.
32