ENGLISH
Safety information
Operating fluids and cleaning agents can cause skin and eye irritation or damage
►
Always wear protective gloves.
►
Keep operating fluids and cleaning agents out of eyes.
►
Observe the safety information on the packaging of the operating fluids and cleaning
agents.
Troubleshooting
The dispenser only works when installed and, if applicable, when the housing is
closed (surface-mounted dispensers).
Fault/LED signal
LED flashes red slowly
LED flashes red quickly and
dispenser inoperative
LED lights up red and
dispenser inoperative
LED lights up orange and
dispenser inoperative
LED is not illuminated and
dispenser inoperative
8/28
Cause
Batteries almost empty
Pump jammed
Batteries empty
Incorrect battery polarity
Magnet in the housing or in
the pump bracket is missing
or pump bracket is bent
Batteries missing
Plug-in power supply not
plugged in correctly
No power or plug-in power
supply defective
eModule not positioned
correctly in rear panel
Sensor Liquid Soap Dispenser
Sensor Disinfectant Dispenser
Solution
Change batteries
►
Clean pump, replace if
►
necessary
Change batteries
►
Insert batteries correctly
►
Replace magnet or align
►
pump bracket
Insert batteries
►
Insert the plug as far as it
►
will go
Alternatively, insert batteries
►
If the dispenser is working:
Check power connection
►
Replace power supply if
►
necessary
Insert the eModule properly
►
(see page 24)
User Guide for Maintenance and Care