Transport And Storage; Installation - oventrop Hydrocor WM 120 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Hydrocor WM

Transport and storage

Material
Insulation
Insulation of the foil
coating
Insulation of the cover
Storage cylinder
Anode
Operating fluids
Potable water side
Heating side
4. Transport and storage
Transport the product in its original packaging.
Store the product under the following conditions:
Temperature range
Relative air humidity
Particles
Mechanical influences
Radiation
Chemical influences

5. Installation

DANGER
Risk of injury from pressurised components
!
Only carry out work on the heating circuit or
the potable water circuit when the system is
depressurised.
!
Observe the permissible operating pressures
during operation.
139501080-V02.09.2021
CFC-free PU rigid foam
PVC
PS
Steel S235JR enamelled
according to DIN 4753
Magnesium
Potable water according to the
German Potable Water
Ordinance (TrinkwV)
Heating water according to VDI
2035
Mixtures of water and glycol
-20°C to +60°C
max. 95%
not condensing
Store dry and free from
dust
Protected from
mechanical agitation
Protected from UV rays
and direct sunlight
Do not store together
with solvents, chemicals,
acids, fuels or similar
substances
NOTICE
Damage to property due to lubricants
Seals can be destroyed by the use of grease or oils.
!
If necessary, flush dirt particles and grease and
oil residues out of the pipework.
Observe the maximum tilting height (see section
3.3 on page 22) of the storage cylinder when
transporting through doors and narrowings.
Keep a sufficient distance from the wall when setting up
the cylinder. A distance of 300 mm from the wall is
sufficient for assembly and subsequent maintenance work.
Make sure there is a sufficient distance from the ceiling to
ensure regular replacement of the anode. The required
distance from the ceiling depends on the size of the anode
(see section 3.3 on page 22).
Fig. 3:
Distance in mm for type 120 and 160
Fig. 4:
Distance in mm for type 200
1
cient load-bearing capacity (even when the storage
cylinder is full). You can compensate for slight
300
300
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hydrocor wm 160Hydrocor wm 200139501013950111395012

Table of Contents