Eurotops BK613 Instruction Manual

BK613/BK613B/50215/50510
PLEASE READ THE MANUAL BEFORE YOUR FIRST USE. KEEP THIS MANUAL SAFE FOR
FUTURE REFERENCE!
LCD 1
LCD 2
1. Press and hold button S2 for 10 seconds, the LCD will flash and display "RST". DO NOT STOP TO HOLD
BUTTON S2 UNTIL THE LCD SCREEN SHOWS " RST ".
2. The hands will fast spin. Please be patient until they stop running.
3. The hour hand and minute hand should point to "12" position. The second hand may have a slight offset, press the
bouton S2 stepwise to adjust it to point to "12" position.
4. When all the watch hands are exactly at "12", don't press any button. The hands will fast spin after one minute
and when they stop, the watch will show the correct time.
The watch will automatically switch to RCC mode at 2:00 AM and at 3:00 AM every day. The signal is always good at
night. If your watch cannot get the signal in the daytime, just leave it nearby a window where the signal is strong
overnight to get a radio signal.
The LCD display shows Signal symbol the reception attempt was successful.
1. Press button S1 and hold for 3 seconds.
2. The second hand rotates to 12:00, The LCD1 display shows the signal reception "
The process will take 3-8 minutes.
Note: For the best possible reception, position your watch near a window in an upright
manner, with the dial facing the window or outdoors. If the watch fails to set itself, leave
it all night long near the window.
The signal cannot be received for the following reasons:
▪
near high buildings.
▪
near a built-up area.
▪
in an area outside the radio signal coverage area.
▪
near electronic or electrical equipment such as TV, wireless radio, mobile phones
computer which may cause undesirable signal interferences.
▪
near sources of magnetism or electro-magnetism.
▪
near heat sources.
▪
in conditions of bad weather.
Radio-controlled Chronograph Set
Instruction manual
INITIAL SETUP
The setup operation is to reduce the mechanical error of the watch hands. It should
be done if you encounter the particular cases below:
•
First time use
•
A loss of synchronization between the hands and the internal saved RCC
time - due to factors such as magnetic fields, important shocks or strong
vibrations.
•
If the watch fails to set itself correctly and RCC signal status has not been
successfully received.
AUTOMATIC SIGNAL RECEPTION
MANUAL SIGNAL RECEPTION
English
".