Eurotops 50050 Instruction Manual

BK609/50050
PLEASE READ THE MANUAL BEFORE YOUR FIRST USE. KEEP THIS MANUAL SAFE FOR
FUTURE REFERENCE!
The setup operation should be done if you encounter the particular cases below:
•
A loss of synchronization between the hands and the internal saved RCC time - due to factors such as
magnetic fields, important shocks or strong vibrations.
•
If the watch fails to set itself correctly and RCC signal status has not been successfully received.
1. Press and hold button B for 8 seconds, the LCD will flash and display "EU" BUT DO NOT STOP TO HOLD
BUTTON B UNTIL THE LCD SCREEN SHOWS "RS".
(Note : If the time zone has been changed, the screen will not show EU, but the new time zone code,
please see "Time zone setting" below.)
2. The hands will fast spin. Please be patient until they stop running.
3. The hands should point to "12" position.
If the hands accidentally missed or were far away from "12", repeat step 1 and press button B when the hands are
4.
exactly at "12", the hands should stop running.
5. When the watch hands are exactly at "12", don't press any button. The hands will fast spin after one minute and
when they stop, the watch will show the correct time.
The watch will automatically switch to RCC mode at 2:00 AM and at 3:00 AM every day. The signal is always good at
night. If your watch cannot get the signal in the daytime, just leave it nearby a window where the signal is strong
overnight to get a radio signal.
1. Press button A and hold for 3 seconds.
2. The LCD screen will then show the signal reception icon "
The process will take 3-8 minutes.
Instruction manual
A : MODE
B : SET
Figure. 1

AUTOMATIC SIGNAL RECEPTION

MANUAL SIGNAL RECEPTION

SIGNAL STRENGTH STATE
PERFECT
GOOD
BAD
NO SIGNAL RECEPTION

FEATURES

1. Radio-controlled and DST automatic
switching.
2. 12-hour time format display

3. Time zone setting

4.
LCD screen shows day/date in German or
English

INITIAL SETUP

". Refer to table below for the strength of the signal.
English
Figure. 2