Haier Ampac ZoneSense PLUS Operation Instructions Manual page 25

Set the Reset / Buzzer output option so as the output acts as a Reset or Buzzer function as per the
system design configuration.
If the output is used set as a Reset or Buzzer function by using the Move Up for Buzzer or Move
Down keys for Reset. Press Enter to update the program
Relays
Press Enter then use the Move Right and / or Move Left keys to select a relay that will be operated
by the selected functions in the sub - menu . Press Enter to access the sub – menu then Move Right
and /or Move Left keys to toggle through the sub - menu structure. The sub menu consists off;
Zone Zone
Alarm Fault
For: Zone Zone Fault
Alarm
Press Enter then Move Right and /or Move Left keys to select the Zone Alarm / Fault / Isolate, Input
or Switch then Enter. Use the Move Right and / or Move Left keys to select the Zones and the
Move Up or Move Down keys to set it to be active or in-active.
Active meaning the Zone Alarm / Fault / Isolate, Input or Switch will operate the Relay where
as in–active will prevent them from operating that relay.
Press Enter to update the Program and the Cancel to back out to the previous menu.
For: Reset ACF Isolate
Press Enter then the Move Right and /or Move Left keys to select Reset or ACF Isolate then the
Move Up or Move Down keys to set for Yes or No.
Yes sets the Relays to be reset or isolated when the Reset and / or ACF Isolate buttons are pressed.
Press Enter to update the Program and Cancel to back out to the previous Menu.
RST / BZ
RESET
Screen Showing the Output Set to Reset
Zone Input
Isolate
Zone
Isolate
RELAY 3
R3 ACFIS
NO
Switch Reset
Input Switch
R3 Z . ALM
1...3...5...7
R2 LATCH
YES
MAN1564-3
ACF
Isolate
R2 SWIT
...3...5...7
R5 RESET
NO
25