Table of Contents
Advertisement
4 Level 1 Access
Is a read only menu that allows the operator to reset latched Ancillary Control Facility outputs (IF
FITTED).
In the event an ancillary device trips out or is operated for some reason the latching control of the
device has to be reset to re-establish normal functionality of that device. Press Enter to reset. The LCD
will display the reset progress as seen below and then return to the Default Screen.
ACF TRIP
RESET
Note: Use Cancel at any time to step back out of the current Menu.
➢
interrogate the panel to determine the state of selected outputs;
➢
view any faults that may be present on the FACP.
Note: Use Cancel at any time to step back out of the current Menu.
4.1 STATUS
Status allows the operator to select and view the current state/operating conditions of the active
components listed in the following sub-menu.
Press Enter to view the Status Menu. Press
the Status sub-menus.
Note: The sub-menu headings are in Italic
O/Ps
Brigade
Bell
Alarm 1
Warn Sys
Fault
ACF
Isolate
ASE
Bat Fail
Alarm
Alarm 2
Fault
Note: these screens are only available if the card, module or board is fitted to
the FACP and it is set to Yes in the System Menu
Outputs
ress Enter then
Move Right or
P
System, ACF, ASE, Alarm or Fault Outputs on the Main Control Board.
The LCD readout will indicate if the selected Output is;
On and Normal, or Off and Normal, or Off and Isolated, or On and Isolated, or Output is On and in Fault,
or Off and in Fault.
RESET
EXECUTE
Relays
Fire Fan
Relays 1 to 8
Fan 1 to 4
On
On
Off
Off
Isolate
Move
BELL
OFF / NORMAL
Sample Output Screens
Move Right to move through the menu or Enter to access
.
Snders
I/Ps
Sndrs 1 to 8
1 to 16
On
On
Off
Off
Normal
Off Fault
Left to view the status of the monitored Bell, Warning
WARN SYS
OFF / NORMAL
MAN1564-3
STATUS
FAULTS
Voltage
Software
Battery volts
Version
Charger volts
System Volts
ALARM
OFF / FLT
11
Advertisement
Table of Contents
